|
This Teejet electronic nozzle holder uses a small solenoid to allow for control over a single nozzle
Code: ECS17560A-1/2X7-NYB
Description
Typical application is to fit the end of the boom, where it can be turned on
and off when needed from the tractor or vehicle cabin within ¼ of a second.
Its ideal application is for spraying under fence lines, plantations
or wind breaks where typical spray booms cannont reach.
The Chemsaver requires a 12 volt power supply, which can be found on most vehicles.
Application
Nozzle Holders
Key Features
Teejet electric solenoid shut-off valve
Valve is normally closed for safety
Electric charge energises the coil to open the valve
Removal of the charge allows the spring to close the valve
Coil is rated at 12V, 7 watts
Maximum current draw of 0.75 amps
Valve response time of 0.25 seconds
All wettable parts are stainless steel or Viton
Pressure drop of 5psi (0.34 bar) at 2.27L/min
Pressure drop of 10psi (0.7 bar) at 3L/min
Maximum 100psi (6.8 BAR) spraying pressure at min voltage 12 volts
Specifications
|
